Not by price, and not by a colour code borrowed from another maker. By shaft diameter and shaft length — the two things that decide whether a swab reaches the feature and whether your fixture holds it.
| Tip geometry | What it is for | Models |
|---|---|---|
| Spherical | General cleaning, blind-hole bottoms, connector cavities. Rounded end, no edge to catch on a wall. | 001 · 002 |
| Tapered | Edges and corners where the head has to reach past an obstruction. | 003 |
| Turned-down | Very narrow gaps. The shaft end is turned down before the cotton goes on, so the head narrows without losing cotton pick-up. | 005 |
| Flat-trimmed | Flat surfaces where full contact matters more than penetration. | 006 |
| Ultra-fine | φ1.1 mm — micro-vias, fibre end-faces, fine-pitch contacts. The finest tip we run. | 009 |
Precision cleaning of small features — PCB, optics, sensors, connectors. Six tip geometries on one shaft, so a single fixture covers the whole range.
Larger head, heavier solvent load — for wider surfaces, chamber walls, stencil and fixture cleaning where a smaller head cannot hold enough liquid.
Reach without leaning into the tool. The CS25-003 uses a knurled hardwood shaft at φ2.3 mm — hardwood is stiffer than paper at the same diameter, so the shaft stays thinner and still resists bending.
CS25-005D and CS25-092D carry a D suffix. On the models where that suffix matches a part number you already buy, we quote against your drawing rather than ours — the suffix has meant more than one thing across suppliers, and we would rather confirm than assume.
CS15 series ships 50,000 pcs per carton; CS25 standard 25,000; the 6-inch range 20,000. If your container planning assumes a different carton count, tell us — the pack count can follow your line rather than ours.
We will confirm fit model by model, or tell you where we differ — before you spend money on samples. If it lines up, we send a benchmark kit: three models, three packs each, and a comparison card with a blank column for your own limits.